The effects of conformation and intermolecular hydrogen bonding on the structure and IR spectra of flutamide; a study based on the matrix isolation technique, ab initio and DFT calculations.

In this study, stable conformers of flutamide referred to as an anticancer drug were searched through a relaxed potential energy surface scan carried out at the B3LYP/6-31G(d) level of theory. This was followed by geometry optimization and thermochemistry calculations performed with the HF-SCF, MP2, B3LYP methods and the 6-31G(d), 6-311++G(d,p), aug-cc-pvTZ basis sets for each of the determined minimum energy conformers. The results revealed that flutamide has at least five stable conformers and two of them provide the major contribution to the observed matrix isolation infrared (IR) spectra of the molecule. The effects of conformational variety and intermolecular hydrogen bonding interactions on the observed IR spectra of flutamide were interpreted in the light of the vibrational spectral data obtained for the most stable monomer and dimer forms of the molecule at the same levels of theory. Pulay's "Scaled Quantum Mechanical-Force Field (SQM-FF)" method was used in the refinement of the calculated harmonic wavenumbers, IR intensities and potential energy distributions. This scaling method which proved its superiority to both anharmonic frequency calculations and other scaling methods helped us to correctly interpret the remarkable differences between the matrix IR spectra of flutamide in argon and the condensed phase IR spectra of the molecule in solvents such as KBr, H2O, D2O, ethanol and methanol.

Fecal Sterol and Runoff Analysis for Nonpoint Source Tracking.

Fecal pollution source identification is needed to quantify risk, target installation of source controls, and assess performance of best management practices in impaired surface waters. Sterol analysis is a chemical method for fecal source tracking that allows for differentiation between several fecal pollution sources. The objectives of this study were to use these chemical tracers for quantifying human fecal inputs in a mixed-land-use watershed without point sources of pollution and to determine the relationship between land use and sterol ratios. Fecal sterol analysis was performed on bed and suspended sediment from impaired streams. Human fecal signatures were found at sites with sewer overflow and septic inputs. Different sterol ratios used to indicate human fecal pollution varied in their sensitivity. Next, geospatial data was used to determine the runoff volumes associated with each land-use category in the watersheds. Fecal sterol ratios were compared between sampling locations and correlations were tested between ratio values and percentage of runoff for a given land-use category. Correlation was not observed between percentage of runoff from developed land and any of the five tested human-indicating sterol ratios in streambed sediments, confirming that human fecal inputs were not evenly distributed across the urban landscape. Several practical considerations for adopting this chemical method for microbial source tracking in small watersheds are discussed. Results indicate that sterol analysis is useful for identifying the location of human fecal nonpoint-source inputs.

Labile and non-labile desorption rate constants for 33 PCB congeners from lake sediment suspensions.

Lake sediments contaminated with polychlorinated biphenyls (PCBs) were purged using a gas stripping technique to estimate desorption rate constants. Desorption profiles and modeling of the data clearly show a two-step release of PCBs from sediment suspensions that can be described as a labile (fast) release followed by a non-labile (slow) release. Data are summarized by labile and non-labile rate constants and by mass in each phase as a function of suspended solids concentration for twelve pure congeners and nine co-eluting data sets (twenty-one chromatograph peaks total). Labile desorption rate constants range from 113 days(-1) to 1.43 days(-1) for the 100 mg/l sediment suspension, from 67.7 days(-1) to 2.45 days(-1) for the 1000 mg/l sediment suspension, and from 8.41 days(-1) to 0.946 days(-1) for the 5000 mg/l sediment suspension. Labile rate constants consistently decreased with increasing suspended solids, and, in general, decreased with increasing degree of chlorination (reflected in increasing retention time in the chromatogram). No consistent trend was observed for the non-labile rate constants with suspended solids concentration or degree of chlorination. The average non-labile rate constant for the PCB congeners studied here was 0.154 days(-1) (s.d.=0.158; n=63). The distribution between the labile and non-labile phases also failed to indicate dependence on suspended solids concentration, chlorine substitution pattern, or molecular weight of the congener, although the data from the 5000 mg/l suspension consistently contained less labile components. The average distributions (n=63) were 60.1% in the labile phase and 39.9% in the non-labile phase.

Cosolvent effects of alcohols on the Henry's law constant and aqueous solubility of tetrachloroethylene (PCE).

The effects of selected cosolvents ethyl alcohol (EtOH), isopropyl alcohol (IPA), and tertbutyl alcohol (TBA) on the Henry's law constant (H) of tetrachloroethylene (PCE) in aqueous solutions were investigated using the static headspace method. Alcohols in solution at a concentration around 20% and above acted as cosolvents increasing the aqueous solubility of PCE, which resulted in lower H values for PCE as compared to the value of H in deionized water. TBA, the most hydrophobic of the three alcohols, exhibited the strongest cosolvent effects, while EtOH had the weakest effects. A ln-linear relationship was observed between H and the volumetric fraction of alcohol added. Investigation of the solubilization of PCE in alcohol solutions confirmed the cosolvent trend observed for the three alcohols. A ln-ln relationship was observed between H and the enhanced solubility of PCE at a particular alcohol concentration. It was also observed that the value of H is a function of the enhanced solubility regardless of the type of cosolvent used. The results from this research further define the behavior of PCE in alcohol flooding solutions used in the remediation of PCE contaminated media.